Structure libraryECMA A20.20.03.01RTE

Reverse tuck end box

The everyday folding carton: a glued tube with a tuck lid at each end, the two lids hinged on opposite panels.

Cosmetics, supplements, candles, small electronics: if it sits on a retail shelf in a paperboard carton, there is a good chance it is a reverse tuck end. The top lid hinges on the back panel and the bottom lid on the front panel, so the two tucks point in opposite directions.

That opposite layout is why it is cheap to make: on the press sheet, neighbouring cartons nest into each other's tucks, so less board goes to waste. The carton ships flat with one glued side seam and is closed by hand at both ends.

A1
Inside size70 × 40 × 120 mm
Flat size237 × 229 mm
MaterialFolding carton
LegendCutCrease

Calibrated. Compared with supplier dielines at more than one size. Allowances are still initial values — order a proof before the first production run.

B1

How it closes

  • Top: tuck lid on the back panel, with two dust flaps that fold in first.
  • Bottom: tuck lid on the front panel, also with dust flaps.
  • Side: one glue flap, glued at the factory.
B2

Good for

  • Light retail products packed by hand.
  • Long runs where board cost matters.
  • Boxes that open often: the tucks reclose.
B3

Watch for

  • A tuck bottom only holds light products; heavy ones push it open. Use a snap-lock or auto-lock bottom instead.
  • The bottom lid's fold line runs along the bottom of the front panel; plan the front artwork for it.

What you can change

Drawn by the engine at the size shown. Change it in the generator.

Plus fine-tuning values for the locks, flaps and clearances.

Downloads in the generator: DXF, CF2, PDF and SVG. Downloads need a pacxio account: sign in with your email, no password.

Top
Tuck length

How far the lid's tuck goes into the box; longer holds better

Top
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Bottom
Tuck length

How far the lid's tuck goes into the box; longer holds better

Bottom
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Glue flap
Glue flap width

How wide this strip is

Corners
Outer corner radius

How round the outer corners are

Ask your agent

Paste this into Claude Code or Codex with pacxio installed.

>Make a box with ECMA A20.20.03.01, inside size 70 × 40 × 120 mm

Questions

What is the difference between a reverse tuck end and a straight tuck end?

In a reverse tuck end the top and bottom lids hinge on opposite panels (back and front). In a straight tuck end both hinge on the same panel. Reverse tuck nests better on the sheet, so it usually costs less; straight tuck gives the front panel the same edge at top and bottom.

Which dimensions do I enter?

The inside size in millimetres: length × width × depth (L × W × H), where L and W are the opening and H is the height between the lids. The engine adds the allowances for the board thickness.

What does ECMA A20.20.03.01 mean?

ECMA codes describe folding cartons. A20 is a tuck lid with dust flaps at the bottom, the next 20 the same at the top; 03 and 01 say which panels the lids hang on (front and back), which is what makes it a reverse tuck.

Related structures