Structure libraryECMA A55.20.03.011-2-3 bottom

Snap-lock bottom box

A folding carton with a tuck lid on top and a bottom that locks itself: four flaps folded in order, 1-2-3.

The snap-lock bottom, also called a 1-2-3 bottom or lock bottom, is the step up from a tuck bottom. Its four bottom flaps have cut-outs that hook into each other when folded in sequence, so the bottom carries far more weight and stays shut without glue or tape.

It is set up by hand, which takes a few seconds per carton, and ships flat like any glued tube. That makes it a common choice for jars, bottles, candles and other heavier retail products in short and medium runs.

A1
Inside size70 × 40 × 120 mm
Flat size237 × 205 mm
MaterialFolding carton
LegendCutCrease

Calibrated. Compared with supplier dielines at more than one size. Allowances are still initial values — order a proof before the first production run.

B1

How it closes

  • Top: tuck lid with dust flaps, reclosable.
  • Bottom: four interlocking flaps, folded 1-2-3.
  • Side: one glue flap.
B2

Good for

  • Heavier products: jars, bottles, candles.
  • Short and medium runs packed by hand.
  • A firmer bottom without extra glue points.
B3

Watch for

  • Slower to set up than an auto-lock bottom; for fast packing lines, use auto-lock.
  • The lock needs room: very small or very flat cartons may not fit the flaps.

What you can change

Drawn by the engine at the size shown. Change it in the generator.

Plus fine-tuning values for the locks, flaps and clearances.

Downloads in the generator: DXF, CF2, PDF and SVG. Downloads need a pacxio account: sign in with your email, no password.

Top
Tuck length

How far the lid's tuck goes into the box; longer holds better

Top
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Glue flap
Glue flap width

How wide this strip is

Corners
Outer corner radius

How round the outer corners are

Ask your agent

Paste this into Claude Code or Codex with pacxio installed.

>Make a box with ECMA A55.20.03.01, inside size 70 × 40 × 120 mm

Questions

Snap-lock or auto-lock bottom: which one?

Both hold heavier products. A snap-lock bottom is folded by hand when packing; an auto-lock bottom is pre-glued at the factory and pops into place when the carton is opened, which is faster on a packing line but needs extra gluing.

Why is it called a 1-2-3 bottom?

Because the four bottom flaps are folded in a fixed order, one, two, three, and the last one locks them all.

Do I need glue for the bottom?

No. Only the side seam is glued at the factory; the bottom holds by its own locks.

Related structures