Structure libraryECMA A60.20.00.01Crash-lock bottom

Auto-lock bottom box

A folding carton whose bottom is glued at the factory and snaps into place the moment the flat carton is opened.

An auto-lock bottom, also called a crash-lock bottom, has bottom flaps that are partly glued to each other while the carton is flat. When the packer squares up the tube, the flaps swing into place and lock, with no folding by hand.

That makes it the usual choice when cartons are packed in volume or the product is heavy: the bottom is strong, consistent and fast to set up. The trade-off is extra glue points at the factory, so the carton costs a little more to convert than a tuck or snap-lock bottom.

A1
Inside size70 × 40 × 120 mm
Flat size237 × 205 mm
MaterialFolding carton
LegendCutCrease

Calibrated. Compared with supplier dielines at more than one size. Allowances are still initial values — order a proof before the first production run.

B1

How it closes

  • Top: tuck lid with dust flaps.
  • Bottom: pre-glued crash-lock flaps that open into a locked base.
  • Side: one glue flap, glued together with the bottom in one pass.
B2

Good for

  • Heavier products and high-volume packing.
  • Products dropped in from the top.
  • Cartons that must stand up straight on the shelf.
B3

Watch for

  • Needs a folder-gluer that can glue the bottom; check with your printer.
  • Costs a little more to convert than a tuck bottom.

What you can change

Drawn by the engine at the size shown. Change it in the generator.

Plus fine-tuning values for the locks, flaps and clearances.

Downloads in the generator: DXF, CF2, PDF and SVG. Downloads need a pacxio account: sign in with your email, no password.

Top
Tuck length

How far the lid's tuck goes into the box; longer holds better

Top
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Glue flap
Glue flap width

How wide this strip is

Corners
Outer corner radius

How round the outer corners are

Ask your agent

Paste this into Claude Code or Codex with pacxio installed.

>Make a box with ECMA A60.20.00.01, inside size 70 × 40 × 120 mm

Questions

Is auto-lock the same as crash-lock?

Yes, they are two names for the same pre-glued bottom. Printers use other names too, so check the drawing rather than the name.

Can the top be opened again?

Yes. The top is a normal tuck lid with dust flaps, so it opens and recloses.

Does the generator check that it closes?

It folds the dieline in 3D at your size and board, so you can see the bottom and lid close before you download. A printed proof is still the final check before production.

Related structures