Structure libraryECMA A20.21.03.01Hanger box

Hang tab tuck end box

A tuck end carton with a panel that rises above the top and a punched hole, so it hangs on a retail peg.

Hang tab cartons are made for peg walls: batteries, cables, small tools, cosmetics samples. The back panel continues above the top of the box as a hanger, and the hang hole is cut through it, so the carton hangs straight with its front facing out.

The rest is a regular tuck end carton: a tuck lid on top tucked under the hanger, and a tuck lid with dust flaps at the bottom.

A1
Inside size70 × 40 × 120 mm
Flat size237 × 229 mm
MaterialFolding carton
LegendCutCrease

Calibrated. Compared with supplier dielines at more than one size. Allowances are still initial values — order a proof before the first production run.

B1

How it closes

  • Top: tuck lid that closes under the raised hang panel.
  • Hanger: the back panel extended, with the hang hole.
  • Bottom: tuck lid with dust flaps.
B2

Good for

  • Pegboard and slat-wall retail.
  • Light, flat products.
  • Shelf and peg display from one carton.
B3

Watch for

  • The hang panel adds height to the flat sheet; check it fits your press sheet.
  • Keep heavy products off a single-thickness hanger; it can tear at the hole.

What you can change

Drawn by the engine at the size shown. Change it in the generator.

Plus fine-tuning values for the locks, flaps and clearances.

Downloads in the generator: DXF, CF2, PDF and SVG. Downloads need a pacxio account: sign in with your email, no password.

Top
Tuck length

How far the lid's tuck goes into the box; longer holds better

Top
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Bottom
Tuck length

How far the lid's tuck goes into the box; longer holds better

Bottom
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Glue flap
Glue flap width

How wide this strip is

Corners
Outer corner radius

How round the outer corners are

Ask your agent

Paste this into Claude Code or Codex with pacxio installed.

>Make a box with ECMA A20.21.03.01, inside size 70 × 40 × 120 mm

Questions

Can I change the hang hole?

Yes. The hole's width, height and distance from the top are options in the generator.

Is the hanger double thickness?

In this structure the hanger is the back panel carried up in one layer. If the product is heavy, ask your agent for a reinforced hanger and order a proof.

Which size do I enter?

The inside size of the box itself, L × W × H in millimetres. The hang panel is added above it.

Related structures