Structure libraryECMA A20.20.01.01STE

Straight tuck end box

A tuck end carton where the top and bottom lids hinge on the same panel, so the front looks the same at both ends.

A straight tuck end is built like a reverse tuck end: a glued tube with a tuck lid and dust flaps at each end. The difference is that both lids hang on the back panel and fold towards the front.

Brands pick it when the front panel matters most, for example a window on the front, or a carton that lies face-up in a display: the front has the same clean edge at top and bottom. Because the tucks all point the same way, cartons nest less tightly on the sheet than reverse tuck ones.

A1
Inside size70 × 40 × 120 mm
Flat size237 × 229 mm
MaterialFolding carton
LegendCutCrease

Calibrated. Compared with supplier dielines at more than one size. Allowances are still initial values — order a proof before the first production run.

B1

How it closes

  • Top: tuck lid on the back panel, with dust flaps.
  • Bottom: tuck lid also on the back panel, with dust flaps.
  • Side: one glue flap.
B2

Good for

  • Window cartons and fronts that must look clean at both ends.
  • Cartons shown lying flat.
  • Light products packed by hand.
B3

Watch for

  • Usually uses a little more board than a reverse tuck end of the same size.
  • Like any tuck bottom, it is for light products.

What you can change

Drawn by the engine at the size shown. Change it in the generator.

Plus fine-tuning values for the locks, flaps and clearances.

Downloads in the generator: DXF, CF2, PDF and SVG. Downloads need a pacxio account: sign in with your email, no password.

Top
Tuck length

How far the lid's tuck goes into the box; longer holds better

Top
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Bottom
Tuck length

How far the lid's tuck goes into the box; longer holds better

Bottom
Dust flap depth

How deep the small flaps beside the lid go in; they keep dust out and support the lid

Glue flap
Glue flap width

How wide this strip is

Corners
Outer corner radius

How round the outer corners are

Ask your agent

Paste this into Claude Code or Codex with pacxio installed.

>Make a box with ECMA A20.20.01.01, inside size 70 × 40 × 120 mm

Questions

When should I choose a straight tuck end over a reverse tuck end?

When the look of the front panel matters more than board cost: windows, cartons displayed face-up, or artwork that runs right up to both ends of the front.

Can it hold a heavy product?

Not well: tuck bottoms are friction closures. For jars, bottles or anything heavy, use a snap-lock (1-2-3) or auto-lock bottom.

What files do I get?

DXF and CF2 for the die-maker or a cutting table, and PDF or SVG for artwork. Cut, crease and perf lines are separate, named layers.

Related structures