Structure libraryFEFCO 0203FOL

Full overlap box

A slotted case whose outer flaps are as wide as the box, so they overlap completely top and bottom.

In a full overlap box, FEFCO 0203, the outer flaps are the full width of the box instead of half. When closed they cover each other completely, giving the top and bottom a double layer of board.

That double layer resists punctures and spreads load, so FOL boxes are used for heavy or rough shipments, for long narrow products, and where boxes are handled with hooks or dropped on their ends.

A1
Inside size300 × 200 × 150 mm
Flat size1044 × 556 mm
MaterialCorrugated
LegendCutCrease

Calibrated. Compared with supplier dielines at more than one size. Allowances are still initial values — order a proof before the first production run.

B1

How it closes

  • Top and bottom: outer flaps full width, overlapping completely.
  • Inner flaps ½L.
  • Side: manufacturer's joint.
B2

Good for

  • Heavy or rough shipments.
  • Long, narrow products.
  • Extra protection top and bottom.
B3

Watch for

  • Uses noticeably more board than an RSC.
  • The flap overlap makes the flat sheet wider; check your machine's maximum.

What you can change

Drawn by the engine at the size shown. Change it in the generator.

Plus fine-tuning values for the locks, flaps and clearances.

Downloads in the generator: DXF, CF2, PDF and SVG. Downloads need a pacxio account: sign in with your email, no password.

Windows and hang holes
Tear-open display
Top
Flap overlap

How much the two flaps overlap

Top
Wing width

How wide the side wings are

Bottom
Wing width

How wide the side wings are

Glue flap
Glue flap width

How wide this strip is

Corners
Outer corner radius

How round the outer corners are

Ask your agent

Paste this into Claude Code or Codex with pacxio installed.

>Make a box with FEFCO 0203, inside size 300 × 200 × 150 mm

Questions

0201 or 0203?

Pick 0201 for everyday shipping at the lowest cost; pick 0203 when the top and bottom need double strength or the box is long and narrow.

Can I change how much the flaps overlap?

Yes. The flap overlap and wing width are options in the generator.

Which size do I enter?

The inside size, L × W × H in millimetres.

Related structures